Digium TE210P
Digium TE210P Summary
The TE210P supports E1, T1, and J1 environments and is selectable on a
per-card or per-port basis. This feature enables signaling translation
between E1, T1, J1 equipment and allows inexpensive T1 channel banks to
connect with E1 circuits. Because the TE210P improves I/O speed by up to 10
times, the result is reduced CPU usage and increased card density per
server.
The TE210P supports a 3.3v PCI slot only - typically available on newer
motherboards and in 64-bit PCI bus architectures. The TE205P is for use only
with a 5.0 volt PCI slot.
The TE210P supports industry standard telephony and data protocols,
including Primary Rate ISDN (both N. American and Standard Euro) protocol
families for voice, PPP, Cisco, HDLC, and Frame Relay data modes. Both
line-side and trunk-side interfaces are supported, also included are
advanced call features.
Data Modes
Cisco HDLC
HDLC
PPP
Multilink PPP
Frame Relay
Voice Modes
PRI CPE & PRI NET
NI1
NI2
EuroISDN
4ESS (AT&T)
5ESS (Lucent)
DMS100
E&M
Wink
Feature Group B
Feature Group D
FXO & FXS
Ground Start
Loop Start
Loop Start with Disconnect Detect
Certifications
Telecom
FCC Part 68 (TIA-968-A), IC CS-03, TBR 4, TBR 12, TBR 13, AS/ACIF S038,
AS/ACIF S016
Safety
UL/CSA 60950, IEC 60950, EN60950, AS/NZS 60950
Note: Finland, Norway and Sweden require that equipment using this product
must be located in a Restricted Access Location (RAL).
Emissions
EN55022 Class B Radiated & Conducted
Immunity
EN55024 ITE, EN61000
